Click image to view original image
China Name Plate Manufacturers,we custom name plates,brass plate engraving.
Material:metal,Aluminum,Anodized Aluminum,Brass,Stainless Steel,Polycarbonate,Polyester,Vinyl.
Thickness 2mm, let the natural leveling can be (Note: The above process is controlled within 30 minutes, so as not to increase the liquid viscosity, resulting in inoperable).
6, the substrate 3-5 minutes after instillation Shuijingjiao observe glue surface without bubbles or dust particles, if any small bubbles, usable pin to pierce, found dead have not stream Shuijingjiao to place, with pin lead
Crossing can be.
7, pouring good signs, at room temperature 20 ℃ -30 ℃ cured 10-24 hours harden, becoming left the surface of the crystal plate.
8, in case of stickers, trademarks, etc., in itself is very thin, and the boundary is not obvious, when pouring, likely to cause Shuijingjiao spill to reach 2mm thickness will be difficult, so make Shuijingjiao grasp different situations
, Good control of viscosity in the application process can be placed 1-2 hours to increase the viscosity, adapt thin Shuijingjiao pouring.
9, making more than 2mm thick crystal glue signs, can be divided into secondary Epoxy, after the first dispensing, curing for 3-5 hours, then dropping layer.
10, Epoxy after cleaning, regardless of manual dispensing, or automated dispensing, after the completion of the machinery, equipment, containers are required to clean, because the Shuijingjiao hardened, insoluble in any solvent, and therefore must be
It does not harden before the machine, the containers are required to clean (Recommendation: Use acetone or ethanol)
Epoxy signs of Procedure
Previously we mentioned before, due to the many types of signs, sign making procedure is not the same. Today, we explain in detail the main steps Dijiao signs:
