Recycled Plastic Containers Wholesale

(7) in the machine is running, such as improper adjustment will affect the quality of the product, the common adjustment as follows: A, adjust the number or size of the nose of material, selec the appropriate weight and size of the bottle according to the extrusion core and jacket size. B, mold installation, the clamping bodies to the clamping state, look at the size of the mold to determine the spacing of clamping, on a small mold the entire equipment, large molds to separate from side to side of the device, so loading mode will be easier , pay attention to water mold distance between the tip and the guide bar. Installed mold, the mold to make a certain pressure, so that the mold securely closed. After 6.1.10 production technology by "molding process instructions" requirement to adjust the production process, trial production of 5 to 10 minutes, according to the "inspection process instructions" test the product, commissioning and test products in line with the standard, by the production art randomly 2-3 molded product and the "product first article inspection reports," fill in commissioning the production process parameters and sent IPQC. 6.1.11 trial products by IPQC confirmed after passing inspection before mass production, when the trial product was not qualified to confirm IPQC inspection, IPQC notification by technical staff continue to adjust until after the product before mass production of the first pieces to confirm compliance. 6.1.12 production process should be carefully observed the work of the machine, always check the quality of the situation extrusion blow molding bottles, abnormal situation timely manner. 6.1.13 When downtime, or switch off the inverter device is adjusted to zero, then turn off the motor and heating switch out of the last turn off the power

Medicinal polypropylene plastic bottles (covering) the production process specification switch. 6.1.14 After the cold water valve should be closed down, turn off the gas source (such as an emergency situation, the motor is turned off or out of turn off the power). Also clean up items around the machine, cleaning machine and ground health, replenish oil, and keep the machine dry, clean, pay attention to dust rust. 6.1.15 After stopping the machine to clean and keep clean, as required by the equipment maintenance item table of related items inspected and maintained and recorded. 6.2 6.2.1 Check the system cap injection molding machine, mold, clean the fixture should be intact; 6.2.2 check the machine safety devices, limit switches, timers, operating pressure, flow action action, the heating cylinder temperature settings should be suitable for the production requirements; 6.2.3 check whether there is enough material hopper. 6.2.4 Check whether a clean mold or other foreign matter. 6.2.5 ON injection molding machines and automatic feeding machine power to start the pump motor to close the security door; 6.2.6 will start the switch to automatic clamping, start the cycle injection; 6.2.7 with 6.1.8; 6.2.8 with 6.1.10,6.1.11; 6.2.9 production process to carefully observe the work of the machine, always check the quality of the case cap, abnormal timely treatment. 6.2.10 When you need to shut down the machine after the completion of each action, the products and outlet material removed to convert to manual, the radio station exit, on the cavity spray rust inhibitor, a half-clutch manual lock mode. After the process is complete and the total electrical power is turned off, so that the mold clamping and tailgate has a protective effect.