Where To Buy Small Plastic Bottles

3, capping system: reasonable cover machine, caps add only half, and kept the lid on the track to send lined caps, it normally stamped. If there card cover, push the cap can; if sent to cover the track severe vibration, transfer a small "flat cover switch." Gland port should be aligned with the bottle. If not aligned, stop the machine, remove the bottle, and then open the machine can be. 4, sealing system: when the horn is lowered, the height should be lower than the bottle about 1mm, ultrasonic sealing, the "intelligent ultrasonic generator", ultrasonic frequency between 1-2 cells, you can use "ultrasonic testing" button to test if the overload indicator light, you need to adjust the frequency, the appropriate adjustment knob on the left side. "Pneumatic Test" button to test the height of the horn. If the seal is lax, it may be appropriate to increase the "welding time", but not too large, easy to make caps melt.

5, a bottle structure: while the contact if the clip rotating the dial, while unable to put the bottle, then open the left side of the cage, loosen the screws, rotate the appropriate clip in tighten. 6, "Auto Start" button can not be used to observe the bottom right of the display, an arrow points to "Auto." If the normal boot, but not a part of, you could relay damaged, replac it. Pressure gauge should be kept below the required machine commonly used alcohol wipe 0.2MPa inside the machine to keep clean. When used, the bottle and the cap should be kept dry. Induction insensitive, it may be wet, the wipe can be.

A little plastic bottles of medicinal embarrassment, domestic procurement of raw materials, domestic sales of products, key production equipment to be imported but full of plastic packaging industry urgent need to break the monopoly of foreign high-end status of the market presses a bottle of Evian mineral water and a bottle of ordinary mineral water, even without knowing the price of the two cases, you can guess what bottle price higher. Yes, that is relying on mineral water bottle out of the texture judgment. Although there is currently no publicly available information confirms that a bottle of mineral water bottles in their cost accounting for the geometry, but the relevant industry sources, the price of 5 yuan Kunlun Mountains mineral water costs nearly $ 1 was bottles. Recently, the Global Industry Data analysis research institutes (GIA) the economic outlook for the global plastic packaging industry was analyzed to predict, although the global economic recession caused some impact, but because of growing other food and beverage consumer retail demand for our products, plastic materials fast become the preferred packaging of new products. GIA predicts that by 2015 the global plastic packaging market will reach $ 26.26 billion. Pharmaceutical plastic bottle technology requirements for handling workers' mood even have specific requirements for plastic bottles can be seen everywhere in life, even though China has become the world's largest production base of plastic, but in the plastics packaging industry upstream - plastic packaging machinery industry, in particular, high-end PET bottles, beverage companies packaging line is basically the introduction of imported equipment in the world. "The United States accounted for 24% of the plastic blow molding machine of the global market share, followed by Germany and Japan," the Secretary-General International Mould & metal & Plastic Industry Suppliers Association Luo Hui, told reporters that although many plastic bottles are manufactured in China, but plastic blowing machine can only rely on imports, especially high-end products.

PBM Company is a Plastic Bottle Manufacturers, Plastic Water Bottle Manufacturers, Custom Plastic Water Bottle, 
Suppliers, HDPE Bottle Manufacturers, Plastic Bottle Cap Manufacturers
Website: www.plastic-bottle-manufacturers.com Plastic Bottle Manufacturers