Click image to view original image
INTRODUCTION
Small Flame Ignition is built in accordance with DIN 53438 & ISO 11925-2：Testing of combustible materials; response to ignition by a small flame, with surface ignition and edge ignition.
FEATURE
The combustion chamber is made from corrosion resistant stainless steel, to maximize operating life.
It has large front and side doors for easy access. These are glazed with toughened glass for full view of the specimen during a test.
An extensively adjustable burner assembly, mounted on runners, to enable the small premixed flame to be tilted at an angle of 45degree to the specimen and offered to it in one fluid movement.
Specimen holder capable of housing the specimens up to and including 60 mm thick.
A fully adjustable specimen support frame facilitating lateral movement of the specimen holder so that the flame can be applied either at the specimen centre position, or at laterally spaced points.
Options available:
Multilayer specimen holder
Loose fill specimen holder
Anemometer 0-10 m/s range
Timing device with 0.2 sec divisions
Pressure reducing valve: Between 10 kPa and 50 kPa
APPLICATION
Building Materials
Rail
Automotive Interior
INTERNATIonAL STANDARDS
DIN：DIN 53438
ISO：ISO 11925-2
EN：EN 13501
IEC：IEC 61730-2：2016
SIZE
850 mm (W) X 450 mm (D) X 800 mm (H)
WEIGHT 24KG
INSTALLATION REQUIREMENTS
Gas: Propane with a minimum purity of 95%.
