Japan River Tiepai SH-21JFE hardness hardness

instant access to measurement values probe micro Vickers diamond side head test load and model Range Rockwell hardness Repeatability materials can be tested measured value display numerical memory display unit output operating ambient temperature source of power duration of continuous operation inch ruler the amount of weight

SH-21 (E) Portable hardness tester, the ideal tool for field measurement of
for large steel structures, vehicles, ships, cities, steel construction, machinery, aerospace maintenance field measurement
for unpredictable surface, groove, compact piece of the R surface, metal castings, gears, crank shaft and measuring the hardness of the original
Features:
	minimal prints (about 0.1mm2), could be used to test
read directly hardness (HV, HRC, HS, and HB), without calculating
can be converted to tension (N/mm2)
measure does not affect the measurement of the implementation of Taiwan, no measurement of positioning
the workpiece does not affect the measurement results back
can store 2000 values, custom software can also be used to transfer data to a computer
10 a calibration memory value replacement without re-calibration work
portable charging units facilitate the achievement of field measurements, can be measured iron and steel objects, boats, large parts
complex structures remain intact in the measurement of the workpiece and
can be measured in any direction, without any aids and Compensation
can reduce the cost of periodic replacement of parts
hardness level control according to the hardness and toughness
can output data to an external printer (optional)
measurement range can be set upper and lower limits, beyond which an alert
	1. about 2kgf (20n)	SH-21-E2
2. about 1kgf (10n)	SH-21-E1
3. about 4kgf (40n) manual probe special type	SH-21-E4
	1.	HRC 10-70
2. Verona Hardness	HV 50-999
3. Show Low Hardness	HS20.0-99.9
4. Buloh Hardness	HB 85-550
	HRC: +-1.0HRC, HV: + - (3% rdg) HV,	HS: +-1.0HS, HB: + - (3% rdg) HB,
	principle subject of steel, if the standard test block hardness correction, it also measures the other metal materials
	4-digit LED display with EL backlight
	2000 a
	1HV, 0.1HRC, 0.1HS, 1HB, 1N/mm2 (tension)
	RS-232C Interface
	0-50 degrees
	AC adapter (100-240V) or lithium-ion rechargeable battery
	5 hours (with backlight) 8 hours (without backlight)
	display section 170 (L) * 97 (W) * 50 (H) mm	probe diameter: 40mm Length: 164mm
	display section: About 400g (including battery)	probe and cable: about 400g