Click image to view original image
titianium is a new type of metal ,the performance of titanium is related to the content of carbon ,nitrogen ,hydrogen and ox ygen .The titanium iodide impurity content less than 0.1%，but its low strength ,high performance plastic .99.5%pure titanium is :the density of (ρ)is 4.5g/cm3,the melting point of 172 silicon titanium alloy wear-resisting flooring 5℃，coefficient of heat conductivity is 15.24w/(m.k),tensile strength b is 539mpa ,elongation is 25%,section shrinkage of PSI is 25%,elastic modulus e is 1.078*105Mpa ,hardness hb195
Titanium Characterisitic :high intensity ,high thermal strength ,good corrosion resistance ,good low temperature perforamnce ,chemical active .
TItanium alloy density is about 4.5g/cm3,only 60% of steel ,the strength of pure titanium was close to ordinary steel strength ,high strength titanium alloy than many alloy structural steel strength .Therefore titanium ally strength (strength/density) is much larger than other metal structure materials ,see table ,can be produced the unit has high strength ,good rigidity ,light quality zero components .The engine component,the plane frame ,skin ,fasteners and landing gear and so the use of titanium alloy .
1、Titanium rod specifications:
Titanium rod specifications:titanium and titanium alloy bar light ,titanium alloy bar ,titanium profiled ,titanium square rod ,titnium shaft,titianium stirring shaft ,titanium screw.
The chemical composition of titanium alloy bar should be consistent with provisions of GB/3620.1,buyer the reinspection ,the chemical composition of the devition should be allowed meet the provisions of GB/T3620.2
2、Titanium rod production:
National standard of titanium :TA1,TA2,TA3,TA7,TA9,TA10,TC4,TC4ELI,TC6,TC9,TC10,TC117,GR12,A221
3、Performance standards for titanium rods:
Titanium rods standards of GB,GB/2965-2965,GB/T13810,Q/BS5331-91;
American stnadard :ASTM B348,ASTM F136,ASTM F67,AMS4928
